Saturday, 8 February 2014

Pulse Width Modulation,Simulation Micro controllers(PIC16F877)

Pulse Width Modulation,Simulation Micro controllers(PIC16F877)

This simulation depicts generation of PWM waves using Flow Code Simulation techniques.It will help to understand how to control speed of DC motor using PWM in controllers.

You may also like :

Servo with ADC control input
Stepper motor Control using switches
ADC Simulation In Flow Code 
Pulse Widht Modulation Simulation in Microcontrollers(PIC16F877)

Here is the complete list of projects:

Tutorials for Flow Code Programming and Simulation

Pulse-width modulation (PWM), or pulse-duration modulation (PDM), is a technique used to encode a message into a pulsing signal. It is a type of modulation. Although this modulation technique can be used to encode information for transmission, its main use is to allow the control of the power supplied to electrical devices, especially to inertial loads such as motors. In addition, PWM is one of the two principal algorithms used in photovoltaic solar battery chargers,the other being MPPT.

The average value of voltage (and current) fed to the load is controlled by turning the switch between supply and load on and off at a fast rate. The longer the switch is on compared to the off periods, the higher the total power supplied to the load.

The PWM switching frequency has to be much higher than what would affect the load (the device that uses the power), which is to say that the resultant waveform perceived by the load must be as smooth as possible. Typically switching has to be done several times a minute in an electric stove, 120 Hz in a lamp dimmer, from few kilohertz (kHz) to tens of kHz for a motor drive and well into the tens or hundreds of kHz in audio amplifiers and computer power supplies.

The term duty cycle describes the proportion of 'on' time to the regular interval or 'period' of time; a low duty cycle corresponds to low power, because the power is off for most of the time. Duty cycle is expressed in percent, 100% being fully on.

The main advantage of PWM is that power loss in the switching devices is very low. When a switch is off there is practically no current, and when it is on and power is being transferred to the load, there is almost no voltage drop across the switch. Power loss, being the product of voltage and current, is thus in both cases close to zero. PWM also works well with digital controls, which, because of their on/off nature, can easily set the needed duty cycle.

PWM has also been used in certain communication systems where its duty cycle has been used to convey information over a communications channel.

Read Full Article


Snapshots of simulation showing different stage of PWM generation with varying percentages.

Video Tutorials:


Download the codes here.

No comments:

Post a Comment

Readers' Choice